UbiquitiRouterStation102016-03-30 01:56:55muskRS specs e refresh dei firmware/links92011-01-05 12:03:29Marco82011-01-05 12:02:45Marco72011-01-05 12:01:26Marco62011-01-05 12:00:26Marco52011-01-05 11:59:33Marco42009-05-14 21:08:15ClauzClauz32009-05-14 10:49:22ClauzClauz22009-05-14 10:47:10ClauzClauz12009-05-13 23:19:45ClauzClauzUbiquiti RouterStationBoard SpecsCPU Atheros AR7161 MIPS 24K running @ 680MHz MEMORY DDR 64MB FLASH SPI 16MB Three MINI-PCI Slots supports Type IIIA One USB 2.0 Host One UART Power Supply Range 12VDC to 24VDC Single RJ45 "J1" Is for WAN and Passive Power Over Ethernet Using Higher voltage is recommended since it will use lower current. Typical Power Consumption is 3W idle no radios present. 5W idle One Radio present. 7W while passing 100Mbps traffic. J1 Single WAN port 10/100 J2 Dual Lan Port 10/100 Ethernet Phy switch, ADMTEK "Infineon" ADM6996FC SerialeUART J3 6 pin Header Terminal Settings 115200 baud, 8 bits, no parity, 1 stop bit. Pin Out
Pin1 3.3VDC
Pin2 S_in
Pin3 NC
Pin4 NC
Pin5 S_out
Pin6 GND
Indirizzo di default: 192.168.1.20 user: root password: ubnt Compilazione OpenWRTIn caso si volesse compilare la propria immagine OpenWRT scegliere: architettura: ar71xx target platform: Ubiquiti RouterStation Immagine OpenWRT precompilataBarrier Breaker BarrierBreaker > ar71xx > generic > openwrt-ar71xx-generic-ubnt-rs-squashfs-factory.bin Oppure Chaos Calmer ChaosCalmer> ar71xx > generic > openwrt-15.05.1-ar71xx-generic-ubnt-rs-squashfs-factory.bin Immagine pronta (old)openwrt-ar71xx-ubnt-rs-squashfs.bin Flashing dell'immagineTenendo premuto il tasto Reset collegare il cavo ethernet sulla porta PoE. La board sarà alimentata. Tenere premuto il Reset per qualche secondo (10 circa) fino all'accensione del led RF. La routerboard è ora pronta sull'indirizzo 192.168.1.20 per il put in tftp. Impostare un indirizzo statico sul nostro PC (es. 192.168.1.100/24). Pingare la RS per verificare l'effettivo tftp boot. Flashare via tftp client via porta WAN (PoE) verbose
Verbose mode on.
tftp> bin
mode set to octet
tftp> put openwrt-ar71xx-ubnt-rs-squashfs-factory.bin
putting openwrt-ar71xx-ubnt-rs-squashfs.bin to 192.168.1.20:openwrt-ar71xx-ubnt-rs-squashfs-factory.bin [octet]
Sent 2032024 bytes in 5.0 seconds [3254323 bit/s]
tftp> ]]>Attendere il riavvio automatico della RouterStation. Connettersi alla porta LAN (nonPoE). Entrare in telnet o via browser su 192.168.1.1 e aggiungere la password.